I found a V6 with a strut brace, but there is none made specifically
for the V6, but this person did adapt one from somewhere. I could
not EMAIL the dude, cause I have no email address, but here is a PIC of
the brace in a V6. It is from Neuspeed, but I could not find a specific
listing at their site either.
See it along the firewall threre? You see the bar is also mounted
to the sides of the towers, not the top where most bolt on, so this must
be for another make, but adapted for the Avenger. So, there IS one
out there somewhere.
Oh, there is an AEM cold air intake there, and lots of red wire-loom.
I put ELECTRIC Type AIR HORNS on mine, but mine are in the OE Locations,
that is pretty unique where those ones are, nice battery, mine will be
a Gell Cell pretty soon! I tried a cool air intake as such, and it
just pulled in to much water and dirt. I went back to my open face
airbox.
The update as of 12/18/2002 from Neuspeed is: The strut brace
was for the Mitsubishi Eclipse, and is no longer in production, and they
do not have any back stock. They will only produce them if there
is an order from a club or group.
LOWER STRUT TIE BAR
I also found this on the web. There were no specific instructions
on how this attaches.
A Lower Front Suspension Stiffener Bar for the Dodge Avenger and Chrysler
Sebring. This is also called a lower front tower bar or lower strut bar.
It locks the two front suspension towers together. It GREATLY improves
handling and cornering by decreasing body roll and the twisting of the
uni-body in hard turns.
Although these bars were originally designed for the 1995 Avenger with
the V-6 power plant, they can EASILY be modified for the I-4 and all years
of A/S cars. They will also work on the 1995-2000 Eclipse with minor modification.
We have not tested it but it should also work on the early Stratus and
Diamontes. Please note: These bars do not reduce under-car to road clearances
and do not strike speed bumps. ALL NEW Dodge, Chrysler and Mitsubishi cars
now come with these lower suspension stiffeners from the factory.
There is also a REAR version for the 1995 to 1999 Mitsubishi Eclipse.
They should fit on the Avenger as well. Sample picture below
